AWS CloudFormation can be used to automate the creation and teardown of your AWS cloud resources in a repeatable manner. Philter can be included in your CloudFormation templates to also automate its deployment and configuration.
To begin, you must have the AMI identifier (e.g. ami-123456789) of Philter. To get the AMI identifier, launch Philter from the AWS Marketplace. If you have not already you will be prompted by the AWS Marketplace to subscribe to Philter. At the end of the subscription process you will be able to launch an instance into your AWS account. (You can select the smallest available instance size.) Do this and then navigate to your EC2 instances in the AWS Console.
In the EC2 Console locate the newly launched Philter instance. It will likely still be in a "Pending" state if not already completed launching. Click on the instance such that its details are displayed at the bottom of the EC2 Console. Locate the "AMI" property. This is the Philter AMI identifier. Make a note of this AMI or copy and paste it so you can reference it in your CloudFormation templates. You can now terminate the instance.
If you are unable to successfully find the Philter AMI identifier please contact us for assistance.
You can use the AMI ID to launch one or more instances of Philter via your CloudFormation template. You can launch a single instance, multiple instances, or you can launch one or more instances as part of an autoscaling group. You have flexibility depending on your requirements for deploying Philter. In the example below we are going to launch a single instance of Philter.
We are going to base our template off the AWS sample for a single EC2 instance in a VPC. The sample template can be found here and attached to this page. This template creates a new VPC along with the required subnet and route table. Open this template in your favorite text editor and locate the AWSRegionArch2AMI mapping. For your region, replace the value for the AMI with Philter's AMI you previously found. Next, locate the security group for the template that exposes port 80. Replace 80 with 443 to be able to access Philter's API. (You will also likely want to change the security groups' inbound CIDR from everyone (0.0.0.0) to a specific host or set of hosts. Save and close the template.
Note that we only replaced the Philter AMI for your region in the template. The Philter AMI identifier will be different for each region.
Now that we have the template we can create a stack from it. A stack is the set of resources that the template defines. You can think of a stack as being an instance of the template. We will use the AWS Console to create the stack. In the AWS Console navigate to the CloudFormation console. Locate the button to create a stack, walk through the steps uploading your template when prompted, and finish. Your new stack with Philter will now be launched. You can watch the stack's progress as CloudFormation creates its resources. When you are finished with the stack you can delete it and all resources that were created for the stack, such as the Philter instance, will be deleted.